Connect camera to Ethernet connector (RJ45).

Camera

GK7205V300+IMX335 IP Camera Module Board 6MP 3072*2048 P2P ICsee XMEYE Human Face Detect Radiator Low illumination Onvif H.265














Cable:

Signal name     J1 connector     T1 pin
TX+ 3 23
TX- 4 22
RX+ 5 20
RX- 6 19


Comments

Post a Comment

Popular posts from this blog

900V power supply. Part 1.

Image
We need a high voltage power supply. I am going to use DC/DC 12 to 300V boost converter schematic based on UC3843. Fig. 1. UC3843 based 12 to 300V  DC/DC  up-converter. To achieve even higher voltages I am going to use 3 identical secondary coils instead of one. This would give us 3 x 300 = 900V. Although it is less than 1200V used in original design I think we can start with this voltage. Special bobbin has been designed and 3D printed to incorporate 3 secondary coils. Coils are separated to avoid insulation breakdown. Fig. 2. 3D-printed bobbin for EFD25. Each secondary coil should be a accompanied by separate rectifier diode, RC snubber and output capacitors of course. The PCB has been designed in a way that all these elements are placed together inside a dashed rectangular area. So I don't have to order additional PCB from the factory, I can simply cut it from those PCBs that I already have.
Read more
Audio/Video over RTP With GStreamer (Linux) Encoding: gst-launch-1.0 videotestsrc ! videoconvert ! \ x264enc ! rtph264pay config-interval=1 pt=96 ! \ udpsink host=127.0.0.1 port=5000 Decoding: gst-launch-1.0 -v udpsrc port=5000 \ caps='application/x-rtp, media=(string)video, clock-rate=(int)90000, encoding-name=(string)H264, payload=(int)96' ! \ rtph264depay ! avdec_h264 ! videoconvert ! \ clockoverlay valignment=bottom ! \ autovideosink fps-update-interval=1000 sync=false
Read more